Pro-Line Clear Body, Supersonic Speed Run: Slash 4×4

This is a Supersonic Speed Run Body for Slash® 4×4. Are you looking to convert your Slash® 4×4 into the ultimate Speed Run vehicle? Look no further than Pro-Line’s all-new Supersonic body built from the ground-up to go fast and look good doing it! There is a whole community built around pushing the limits of speed with the Slash® 4×4 (and other SC-based trucks) and the Supersonic body will help you jump right in. Belted tires are a must for going fast and the Reaction HP SC tires and even the Avenger HP 1:8 tires pair perfectly with the Supersonic body! Make sure to get the Pro-Line Extended Body Mounts so you can slam the body as low as possible and wide offset hexes to add even more high-speed stability to your build and to fill out the wheel wells. Get your very own Supersonic Speed Run body today! They are going to go fast!

• Ultimate Slash® 4×4 Speed Run Body!
• Designed to Go Fast and Look Good Doing It
• Pairs Perfectly with Pro-Line’s Belted SC and 1: 8 Street Tires
• Made with Crystal Clear Polycarbonate
• Fits on: Slash 4×4 (with extended body mounts and wide offset hexes)
• Use Pro-Line Extended Body Mounts to Get the Body Mounted Perfectly
• Add Wide Offset Hexes to Gain Stability and Fill Out the Wheel Wells
• Four steps to Speed Run Ready:
• 1) Clean Body and apply included window mask
• 2) Paint then peel the over-spray film off
• 3) Sticker your body (decal sheet included)
• 4) Mount your new body onto your truck
• Made in the USA, since 1982

Length: 26.0″ (660mm)

Width at fenders: 12.7″ (323mm)

Height: 5.6″ (142mm)

Wheelbase: 12.8″ (325mm)